PDA

View Full Version : Gas-thru fore-grip w/max-flow ???

icebluefly
02-04-2002, 03:13 PM
Will this work?

I was thinking of putting a gas-thru fore-grip instead of the reg and use the max-flow air system but where would i adjust my velocity???

OR just leave it alone?

Any help would be appreciated and thanks!!
Moose
02-04-2002, 08:29 PM
you would still adjust your velocity using the lpr.

it would probably work fine
mike da bushman
02-04-2002, 10:25 PM
it would be more than fine to use the max-flo with a gas thru grip max-flos were intended to be used single regulated as for adjusting your velocity you would use the regulator not the lpr....mike
Moose
02-05-2002, 06:35 AM
um...mike...the only regulator available after replacing the inline reg would be the lpr.
icebluefly
02-05-2002, 06:56 AM
So...which is it the LPR in front of the gun or the reg on the max-flow???


All this help is greatly appreciated!
mike da bushman
02-05-2002, 07:08 AM
anonymous the lpr is the low pressure regulator this controls the ram not the velocity to get higher or lower velocity you would have to adjust the max-flo....mike
mike da bushman
02-05-2002, 07:16 AM
as for the regulator the max flo air system has the max flo regulator on it already and its one of the most consistent on the market theres no need for another inline reg all you would be doing is restricting airflow also i would recomend getting a sonic lpr gauge that way you can correctly set your lpr at 90 psi....mike
icebluefly
02-05-2002, 07:25 AM
Thanks Mike!

I just so happen to have an extra gas-thru and an extra max-flow air system so i thought i'd try it!

Thanks again Mike,
Oliver
splatterpunx
02-05-2002, 09:50 AM
to adjust your velocity ,you adjust the input from the maxflow
and dont mess with your lpr,i use a maxflow/with a gas through
grip and it works great!

some people have had efficiency problems with that set up
but to date ive had no problems

also your going to need ,if you dont allready have a aftermarket reg adapter for the bush

and make sure you have the LP spring on the max!!!
or your bushy will go bo0m!
Moose
02-05-2002, 02:53 PM
Oh my...crap!...I must have gotten confused. I could have sworn that the users guide said to adjust the pressure by the lpr. dont get mad, im new to this gun :confuse:.