Mag-guy Read this on ROF pot

[johnnyrotten]

Here is the Rate of fire pot, I was using a small screwdriver to point at it, but first PLEASE adjust your trigger so its not hair tight
The writing above the pot will say "semi" turn it CCW 1/8 of a turn, then try shooting again, if your still chopping turn another 1/8 of a turn

[Impy4335]

thanks man, that will help many new peoples. Any idea on whether me missing one screw (the one closest to the led) will cause a problem?? What size are they?? Thanks man, youre awesome.

[johnnyrotten]

Im not really sure what size they are maybe 4-40 or could be a small metric, if you bought your Imp from e-paintball give me a call wednesday after 4 eastern and I'll get you one sent out, BUT AGAIN :) I dont work there I just help out some for no pay, but I get compensated other ways, because Im on the team

[wolverine]

The screws that hold the board to the solenoid tray are 2-56. I searched high and low to find some and finally found them at Radio Shack. Here is the information:

Cat No. 64-3010A
Round Head Machine Screws (42)
Cost: $1.49
Contains 14 Each: 2-56 x 1/4", 1/2" and 3/4"

You will use the 1/4" ones.

[johnnyrotten]

Wolvy you DA MANG!

[Impy4335]

Da-mang huh? Thanks. You didnt need to do all that with your bad back and all. I just read this Thursday so its too late to call, but I can just stop in at a 'Shack and get one. Better yet might be Ace Hardware. One guy at ours plays too. Hes nice and helpful. Helped me find scews for my maxflo once. Thanks again you guys, and rotten, where would you get one from? do you keep parts there too? or would you steal one from a teamate:badboy: