adjusting the response trigger

[tofusquare]

i just recently installed the response trigger and it doesn't really work at all. whenever i fire the pin doesn't always push the trigger back to it's original position sometimes every once and a while it works for a couple seconds and shoots a lot of shots but it usually doesn't work i'm pretty sure it's connected right because the co2 does get to the rt valve maybe i don't have the two adjustement screws adjusted right does anyone have any tips on how to fix or adjust this? i have tried pulling the trigger in many different variations to softly hard gently and it still doesn't work

[Mimos]

It just takes lots of fiddilin' with. Make sure that everything is tightly connected. I usually keep my adjuster about half way to 3/4 the way up at most. If you have it turned up too high, then the piston pushes the trigger back too hard for you to keep the right amount of pressure on it. Start out witht the adjuster half way up, then pull the tirgger just enough to make it fire a round. You will feel the piston push the trigger back. Now remember how much pressure was needed to make it fire the first round? Keep that same or slightly more pressure on the trigger to make it keep fireing. Then let go when you want it to stop. (when the tanks starts to get low, then turn the adjuster all the way down. Mine went bannanas :crazy: once. It kept fireing with out me touching the trigger.)

[Mimos]

Oh, btw, if you still have problems tippmann might have some good advice as well. Just don't get discouraged, keep at it, you'll get the hang of it.