Gauge on Max Flow Inline Reg

[C]-[iLDe]

I wasnt sure where to post this; the marker in question is a cocker, but the inline Max Flow Inline is an Impulse reg. Hopefully someone here knows the answer.

Is it posible to put a gauge in one of the inline Max Flow's air out ports so that i can see my operating pressure? I already have my Macro fitting connected to one of the top ports, does the gauge need to go to one of the bottom ones? Should I switch them? Is this even feasible? Any help would be appreciated, thanks.

[wolverine]

Yes you can do it as you specified. Just make sure that the Guage is on an output port and not an input port.

[C]-[iLDe]

Thanks Wolverine...Excuse my ignorance, but could u elaborate? How do i tell the output ports from the input ports? Are the inputs on the top and outputs on the bottom? vice versa? Please advise.

[Impy4335]

one side will have 2 ports. One of those is input one is output. atleast, thats what I think it is. All other ports are output. Just use the top one on the side with 2 holes, and youll be fine. If you take out the 4 l;ower screws, you can see the piston. That is how I tell