New Member of the Cyborg Family....for now

[.:{}:.]

Yup, i got one. Shot about a hopper through it and dry fired it a little bit. So far so good. Got to see how it holds up in a game this weekend though. So we'll see. :)

More Pics will be up later. But for now, here is a little teaser:
http://i4.photobucket.com/albums/y108/Hobasher/borg1.jpg

[Tabris17]

05 Borg I take it? I see the Sonic grips. If you don't have a NOX or Tadao board in that baby yet, look into it. Makes them rip even faster then they already do, but I'm sure you'll fall in love even more once you start mowing faces.

[.:{}:.]

Yessir, sonic internals, 05 borg.

In all reality i got a great deal on this gun and was just planning to resell it and make some extra dough, but i love the way this thing shoots. I might look into tadao.

[Tabris17]

I would give the Borg time before you go and resell it. They're simply amazing markers and perform like a dream. But also now you can get the 07 red valve from PBK for it, fits all Borg models and should make the operation smoother and allow you to lower your dwell slightly. Especially if you get the PBK light weight delrin ram.

[.:{}:.]

You seem to be the borg tech, so i'll ask you my question here.

In the manual i got it says to adjust the velocity through the LPR and then i also got a piece of paper that said manual add on. this said quite the opposite. It said the lpr should be set at 80psi and adjust velocity through the gladiator. Which one is correct?

[kylec]

I believe (and correct me if I'm wrong), the way to set up the borg is as follows.

Gladiator set to 200.
LPR turned out so the gun doesn't cycle.
Turn in the LPR until it does a full cycle (you will hear the difference, the valve will sort of "pop")
You want it to cycle properly even when shooting 8 bps or so.
Give the LPR another 1/4 turn in to make sure there is no drop off.
Get desired fps through gladiator.

[DirtyBirdy51]

nice food. good luck

[.:{}:.]

Thanks. We'll see if I keep it or not this weekend