LPR help

[flijub365]

I have a max flow LPR on my impulse and when I was cleaning my gun, I tightened the elbow too far and sheard the hollow bolt. I was wondering if I could run this LPR without the tapeworm and the elbow (I think its tapeworm?) http://www.smartparts.com/Store/S/max-flo%20LPR%20%20chr.jpg (http://www.smartparts.com/Store/default.aspx?Prod={DEF4375C-DFF2-43B5-AAD0-7618973089C6})http://i5.ebayimg.com/02/i/07/3d/47/ca_1_b.JPG

[flijub365]

never mind, I just tried it and it leaks from where the tapeworm goes.

[mgitlin]

JB Weld and a tap :tup:

[Yakb0]

you could just buy another one. 'cocker hose fittings are a standard size, so your proshop should have a replacement. Of course, it probably is just a barb, with no swivel or locking collar.

[mgitlin]

wait, I'm confused. I thought he stripped the threading out of the port on the LPR.

If it's just the elbow you're looking for then a QEV could work(I think), or any 90* cocker hose fitting.