should my paint do this??

[TwiZtiD688]

i have use diff. kind of paint and i was wondering sould it just fall right through the barrel or should it get stuck alittle ?? i heard that it should get stuck a little and not just slide right through witch is right? i have a 32degrees whisper and i was wondering what size bore it was too

[coolcockerguy]

you don't want paint to get stuck but you also don't want paint to just roll through. the perfect match is where you can pretty easily blow the paint through the barrel

[TwiZtiD688]

thats what i ment by stuck

[Henry_the_Lion5]

It should get stuck somewhat. But not where you can't easily blow on it and it flys through barrel. it shouldn't just fall through either.

[AK47]

If you hold the barrel vertical, shouldn't it lightly stick to the sides?

[PartsMart]

Well if your balls r rolling out ur barrel when its attached to the gun, uve got a problem, u need to get a ball detent. Otherwise just fit the paint to ur barrel

[NcicHit]

If you tried a larger paint and it still rolls out your paintball gun is ineed of repair like the above post mentions (ball detent). I was using small bore paint in my Micromag with a Smart Parts All American medium barrel and I had one roll out my barrel when I held the gun down. I just switched to my BOA and didn't have any problems. The barrel size and paint does make a difference. Just check out the charts in this forum and you should be okay. There are quite a few Internet sites with paint and barrel charts on them.