red dot

[Jordan31]

i bought a new red dot sight to put on my tippmann a5
http://www.pyramydair.com/images/acc/reddotsight.jpg

it doesnt fit on the a5 right now, it will fit on the big (lower rail)
but the small rail on top of the a5 is in the way

i was just wondering if i could take a dremel or something to grind away some room on the top for the screws that attach the red dot, without damaging the a5

thanks

[PTE. O'Hearn]

I would imagine you could, just be careful not to grind too much.

[hellomynameis]

Or you could get a sight rail. It is a lot easier to see when its higher (especially with a mask on) and it'll most likely solve your problem. The only problem is that it would cost you about 25 bucks.

[TheMaverick]

Word up son it seem you are haveing some problems with your red dot i am also haveing the same problems with my scope of the shotgun decent witch i have decided to connect with an offset site rail from special ops


Ps brush your teeth b4 bed