b2k4 valve

[~CJW~]

ok, so my b2k4 was leeking and the bolt wouldnt cock back so i took it into a paintball shop, they fixed so i can use it but i still leeks alot, i need to get a new valve for it and i think a cup seal, how much are those parts and where could i get one?

[akathewolf]

ICD for show i bet... or if someone is parting out a bushmaster which i have seen a lot of lately you can always buy the parts you need from someone... also you might be able to order through a shop/have one custom made depending on where you go, may cost you tho.

[DR. ZOIDBERG MD]

http://www.paintballtrader.com/v4/product.php?productid=16241&cat=315&page=2

[ccmu]

Ebay also has one. I've got a stock one lying around, but Ebay valves are only $17 and work well.

[~CJW~]

hmm, ok thanks guys.

[DR. ZOIDBERG MD]

i heard darryl say ebay can hurt ur performance in some cases

[lotus_esprit5]

if its leaking out the barrel, its not the valve itself unless there's some sort of manufacturing defect. most likely its the cupseal. make sure it is well lubed, and try tryfiring the gun a bit if its a new gun, the cupseal may just need to be broken in (although this is rare on stock cupseals). however, if there are noticeable scratches and such on it, then you need a new cupseal, and rather than spend the money on a new cupseal I'd say just replace the whole valve for not much more $.

[adriann22]

I have a stock one lying around and for a few bucks its yours.

Don't get an ebay valve. I've talked to Goldie, Acid, and Greg and they all say that those valve will cause your efficiency to go through the floor. The openings are too big and now ratio'd correctly.

If you want a good valve then get either a Vapor, Mac Dev, or send a Stock one to Acid for him to turn it into an AA valve.