Imagine trigger job

[silentbob831]

I want to replace the stock trigger on my Imagine, but how do you take the trigger off? I tried pushing the pin out that holds the trigger - it won't budge. Not even when I hit it with a hammer and nail. Can anybody help?

[OTEdge]

Hit Harder? Uhmm On a serious note. Im not sure but when you take the frame off, on top of your trigger their should be a allen screw, Yea take that out then try hitting it out (The Pin on the side that is) with a hammer and nail.

[silentbob831]

I took that screw out lol. It looks like the trigger pin was sealed pretty good, still won't budge, and I hit hard.

[di$TOrTed]

Take the trigger frame off the marker. Then, get a hammer and metal punch, or hammer and nail, and hit the pin on the non-star side. If it doesnt budge then just hit harder.

[Abe2112]

NO please dont listen to these guys! they will ruin your frame!


Do you see on the frame, where there is a pin that is holding the trigger? There is one side of the pin with a star pattern and one side with no pattern. You want to tap the side with no pattern with a hammer. If you tap the star-pattern side through, than you will make a huge hole in your frame.