How do I?

[CrazyNinja]

I have a Raven Nexion and i bought a new 32 degrees hp valve for it but i cant get the stock one out and i dont wanna mess up the inside of the gun trying to get it out, does anybody have any suggestions

[SUSPECT 0]

Ya,I've had a problem doing that before a suggestion would be to take something long like a screw driver and put a peice of cloth or somehting soft at the end of it and then try to push it out

[OTEdge]

Yea suspect is correct. Long as it is soft it will most likely not damage the valve. Make sure the locking screw is out and take a long battleswab/squeegee and just push it out of the front end.

[413sonix]

Remove the trigger frame and VA. Then take off the brass set screw on the bottom of the marker and I usually use the eraser end of a pencil to get my valve out of my Spyder. Be careful not to scratch it, if it does become scratched then you'll need to buy a replacement.