invert mini manual, FAQ

[lear-pilot]

hi there guys there is the link for the invert mini manual, A must read, answers a lot of FAQ, full of great info like the fact that they perfer low pressure air.
http://www.invertpaintball.com/myspace/Myspace_Manual.pdf

[TríVíuM]

Ty Cool

[Uziel Gal]

Many thanks - added to the FAQ sticky.

[4x4le]

People need to keep in mind that the mini manual, although it can be usefull, has many misinformities in it. Such as modes that the board does not have and the such. Also, it has been said by the manufuracture that hp or lp dont matter. Lp will be a little easier on your reg so it wont need serviced as ofter, but they actually recommend hp as far as I can tell now because it will garauntee that there will be no tank caused shootdown.

[lear-pilot]

Invert manual page 7. in red capital letters in the manual so they must think it is important, "THE USE OF A LOW PRESSURE OUTPUT COMPRESSED AIR SYSTEM IS STRONGLY SUGGESTED" A with such a small and new regulator I am going to take there suggestion and use a low pressure output tank, in testing Crossfire tanks are the best out there.

[di$TOrTed]

It says that HP is acceptable though, they just recommend LP. Also, I think the thing on page 7 was more of saying not to use co2, to use HPA but yes it does specifically say low pressure but I just think that is what is preferred.

I'm sure HP will work great w/o any problems.

[4x4le]

It will. Simon Stephins specificially stated it on a forum where He is a moderator on (i wont mention which one) He encouraged people to not worry weather they have a hp or lp tank

[Vague312]

eh dont worry about it. either way the mini reg will only push 200psi into the marker. If its recommended and you dont have a tank go for it but if you already have a hp tank it shouldn't do much. To early to tell thus far.

*edit*
with the board programming in the manual. To adjust the settings up and down you must hit the up/down buttons when the led first lights up.

hit button 3 times- solid orange lite (Dewll) - then it blinks the value
adjust it when the lite is solid orange

it might just be me but it reads like you adjust it after the board blinks the value.

[4skins23]

I actually got the mini for my son and I was messing with it the other day. You hit the function button like 3 times then it goes solid orange then is when you want to turn it up or down.If you don't do anything it will go out and then blink to where it is currently set.