got my new impulse but pull pin problem

[chandlern1]

ok man i got my rat jr 650 with vision man this thing rips. Ok i went to go put on my drop and flipped my gun upside down (the pull pin was all the way in) and it fell off (voo doo bolt) it keeps happening so what to do?just get a new pull pin?

[XSycloneX]

it wouldnt be the pin. its probably the bolt. check to see if the ball bering thing (inside the bolt) that hold the pin in place is there. Do u know what im talking about?

[Organized Chaos]

Hey Egg roll!
How about we trade bolts ;) ...........when you get it working! cause mine works

[chandlern1]

so how do i adjust that? the smart parts logo is in the way

[Phweedo.com]

I don't know about the voodoo bolt but mine and several other types of Delrin bolts have a allen key in the back which you can use to tighten or loosen the ball bearing. There will be a whole that they drilled somewhere to put that in. Weither its at the back (maybe covered up by a jewel) further up on the bottom of the bolt, it should have one.

[Impy4335]

does the voodoo even have a bearing? if not, just keep your gun fight side up, or put someting in to make it fit better

[chandlern1]

the ball bearing is moveing around i guess ill take it off and glue it back on or something unless you guys got any other ideas

[mmhsval]

DONT GLUE IT!! If you glue it you wont be able to get your pull pin in or out. Instead try taking the jewel on the back of your bolt off and see if there is somewhere for you to get in there and work on it.

[XSycloneX]

i think hes talking about taking the jewel off and glueing that back on, not glueing the pin in (that would not be a wise idea-chopped balls, cleaning, ect.). take it to your local shop, they might help fix it for you, or at least tell you what you can do. But wait till FOM replies, he knows everything.

[BLiNDMAN]

if you take off the jewel you will see the allen screw

[chandlern1]

have you done it before? could you get the emblum back on?

[BLiNDMAN]

yeah.. i used a needle to take off the jewel... mine came off pretty easily... not sure how hard yours is to take off..you could also use a really small precision screwdriver.. when i put it back on i used a tooth and put some crazy glue around the edges of the jewel so that i don't get glue all over the place. this also makes it easier to take off again if you need to.

[chandlern1]

ok i just did it i made little wrinkles in the emblem:( but it work not noticeable so at least its working i will post picks of my rat jr it is so nice

[BLiNDMAN]

cool