Remotes on PT Pistols - New Accessory Available

[Avery]

Please pardon the minor cross-post.

A friend of mine has started to make quick disconnect fitting for the PT Enforcer, PT Punisher and PT Extreme line of pistols that do not require a bottomline set-up. This means that if you run remote on your primary marker then all you need do to give your pistol virtually unlimited gas (and save a buck a pop on 12g cartridges) is pop your remote off of the marker and onto the pistol - this takes a little less than 4 seconds. The nice thing about this set-up is that it does not impede the pistol being holstered in almost any holster.

Before he starts manufacturing them by the dozen he has asked me to find out how many people are interested in getting one of these. I use one of them on each of my CORE PT Pros and, personally, I'd never go back.

So, this is not an advertisement. I am not taking orders, I just want to know how many people are interested. If you think this is neat, please email me at averya@telus.net and thank you.

[Avery]

Okay, $12 US or $18 CDN. ;)

[Lorquas]

isn't that just a regular quick disconnect adaptor? looks or does it have weird threading or something?

[Avery]

It is regular, but it had to have a rare custom thread put on it in order for the fitting to work with the marker.

[Sid]

Well the PT Enforcer I have has a very small hole and I was going to tap and thread the hole anyway. I've had flow problems because the hole is so small. I'm hoping the remote hole is bigger on other PT's.

[Avery]

Well, I'm told that it is the same hole as on the PT Pro, but I've had no trouble exceeding 300 fps at only 650 psi from a compressed air tank. I am told that it is the valve on the enforcer that leads to problems. For instance, as small as that hole can possibly be, it is still far larger than the inside diameter of the piercing pin for the 12g cartridge. It is, in fact, larger than the hole on most ASA adaptors.