Trigger Problem Fixed

[texboy]

I messed around with the trigger and its sensitive and it messed up the gun. The gun would shoot one ball and there would be a red light underneath the flashing green light. a guy there who has a mini knew what was wrong once i screwd with the trigger.

the gun also wouldnt shoot with the eyes off is another way it was messed up. just an idea if you have the same problem.

[<IONFREAK>]

With the HES you can't have the trigger real close to its activation point like a micro-switch. Try adjusting your trigger out farther than usual (sp?) until the red light goes away and pull the trigger a couple of times to make sure it doesn't stick again. Then do the best you can to get used to it. Thats what i did when my mini stuck on red and its been fine ever since.

I haven't even shot it with eyes off (except with no air or paint just clicking the solenoid) so i can't help you there.

[blinkimgone04]

1. You may just have to keep adjusting it till you get rid of that red light.

2. It sounds like you adjusted it too hard and broke the epoxy bond with the screw on the top front of the trigger and the magnet. All you need to do is take the grip frame off the body and find the little magnet on top of the frame. You will notice one side has a black and clear epoxy bond on the magnet. Scrape that off of the magnet and get some super glue. Tighten the screw on the top front of the trigger to where the top of the screw sticks above the top of the trigger. What you'll do now is put some super glue on top of the screw and place the magnet on top of the screw(center it as good as possible). Let it sit for about a minute. Put the gun back together and your problem is solved.

Hope this helps! :nod: