PDA

View Full Version : bolt not cocking

the_binary_soul
03-27-2007, 12:18 PM
Hey everyone

My promaster still wont cock, I've replaced the internal hose. If I turn the LPR in at all the solenoid starts to leak. Oddly enough though the adjustment screw is almost flush or slightly sticking out ... The gauge on the HPR reads about 240 so air is getting that far. I hope my solenoid isn't dead.
JPW
03-27-2007, 04:34 PM
Does the bolt move freely? Is it properly attached to the ram?
Did this happen after you replaced the hose, or is that why you replaced it?
the_binary_soul
03-27-2007, 04:40 PM
sorry I forgot I posted here. I've fixed it. I replaced the hose because I had problems earlier with it leaking.
hurleyhonda22
03-27-2007, 04:42 PM
Breakdown your gun and check to see if the hoses are connected to the noid, I had this same problem.