Max-Flo Problem [Archive] - Paintball Forums

BadMr.Frosty

03-03-2002, 04:31 PM

when i gas up i notice my needle slowly moves up to 250 then starts to leak from the tank...just wanted to know what is up with this and if i can do anything...

wolverine

03-03-2002, 05:46 PM

Anytime a max-flow is not acting right, it's time for a good clean and lube.

IF that does not fix it, then get an overhaul kit and replace o-rings.

XSycloneX

03-03-2002, 10:22 PM

i dont think your suposed to put a max flo over 200, not good for it. try turning it down to around 180.

2k1AngelShooter

03-03-2002, 10:36 PM

Ya are we talking your out put pressure gauge or your tank? If it's your output pressure its your PRV doing it's job. Under 200 if it's set up for a shocker/imp. If you using it on something else (doubtful) then you'll need to post that.

Otherwise, time for clean and lube.

TruImpulse

03-09-2002, 01:05 PM

actually yah i had the same problem, however instead of replacing everything on it...i replaced IT with a vertical max flow...i think they are much easier and make a nice grip....you can get 1 for $150 from smartparts.com and yah...much better..... and yah..i have my operating pressure at about 154...and its beautiful