Just bought a mini and having a problem

[WingsRDbest]

Ok,
I just bought my mini yesterday, got it home and screwed in my LP 45/45 on it and turned it on. The reg reads slightly over 200psi. Tried to dry fire it and nothing? Tried adjusting the trigger pull, the velocity and the reg pressure but still nothing. Any ideas?

[Crede777]

Is the solenoid clicking? I would suggest putting in a new battery.

Also, check to see that your trigger is activating your board so that the gun fires.

[Mr Virus]

Did you turn the gun on with the eyes off ?

Youll need to squeeze and hold the trigger, then turn on the gun.
This will allow you to dry fire.

[Menace67]

Did you turn the gun on with the eyes off ?

Youll need to squeeze and hold the trigger, then turn on the gun.
This will allow you to dry fire.


beat me to it:D

[WingsRDbest]

I held down the trigger while turning on the marker, still nothing. think the trigger needs to be adjusted, should the magnets be able to touch or not? Also no clicking from the solenoid, only sound is the marker pressurizing.

[Mr Virus]

If you adjusted the trigger screws...namely the top most screw on the trigger...you may have backed it out too far and dislocated the magnet thats glued to the top of the screw.
This magnet operates the HES sensor.

Youll have to remove the grip frame from the guns body, to check the status of that top most screw.
If the magnet has been dislocated, it may be stuck somewhere else onto something metal, or it may be loose...so be careful when removing the grip frame.
Heres the best pic I can offer to show what that screw is supposed to look like normally:
http://www.zdspb.com/media/invert/framedis3.JPG