Need some help please

[impsrock2123]

I just put my nitro into my tank and for some reason its leaking in the front it shoots but only a few times cuz the air is not completly stayin inside heres a pic sorry im not good at explaing but if you have any ?s ill try to answer them the best i can

http://a702.ac-images.myspacecdn.com/images01/95/l_f6116a1e59605101a82f199158ce3cc5.jpg

[impsrock2123]

Nevermind so i fixed that but its not leakin but the reg is not keepin pressure i guess now the little pressure gauge goes from like 200-0 after 1 shot and ithen i have to wait for it to get back up to 200

[BlueImpulse]

I suppose you figured out your inline pressure was too high and venting from the PRV causing your air leak?

About your other problem, your tank reg or inline reg is not recharging properly for some reason. Could be any number of things, lets see...

1. Do you use an adjustable reg tank? If so, make sure your output is high enough for you marker to operate properly.

2. If the answer to #1 is no, disassemble and clean your inline reg. There may be some crud built up in there slowing down the recharge rate.

Just a couple suggestions to get you started.

[rridgeway]

it also happens if you are low on air (not sure if you're using hpa or co2). the PRV will get to work when pressures get above 200 because thats too much for the solenoid the handle.

[m4tty]

use caution when gassing up because if its too high it can blow out the prv. it happened to mine (I didn't realize my reg was set so high) . I don't think its a common problem because I couldn't find anyone else whom it happened to, but still.