Title removed due to profanity filter avoidment.

[5Fingerdiscount]

Ok! So I tried to Zero my regs for the first time ever - and when I turned down my HPR and LPR all the way, and turned on my asa, I heard leaks comin from the HPR (Where the screw is on the other side of the elbow for the microline) and from my ASA (same idea as the HPR) - now I didn't use a sealant for either screws - just cuzz I'm an idiot and didn't read completely... DOH! So should I use a sealant on these screws? or did I **** something up?!?!?! Please HELP!!!!! :crazy:

[hurleyhonda22]

Teflon tape the plug screws. After that just set your regs and your good. If a leak persists Pm me and I can help you out more

[bronze]

Whoa whoa whoa, First use teflon tape, second, ZERO out each reg, then turn the asa on. turn HPR to 220ish., turn lpr until it leaks, then a half turn back.

[hurleyhonda22]

Whoa whoa whoa, First use teflon tape, second, ZERO out each reg, then turn the asa on. turn HPR to 220ish., turn lpr until it leaks, then a half turn back.


He should just turn it a half turn past cocking

[bronze]

i got a lasoya so i just set hte gauges to 220 and 100ish.

But the point is to zero out the regs before u turn the air on and use teflon tape on fittings.

[5Fingerdiscount]

thats what I did - I was zeroing my regs - and I turned on my ASA and thats when it started leaking! - but thanks alot for the help! I really do appreciate it :) I'll let u know how it goes... I'm sure it'll be fine :goody: