Leaking???

[l1ryan1l]

i just got my F7 fusion today and it's leaking out of the things where you put the macroline in, im not too sure if im putting on the macroline right. please tell me all possibilities even if the macroline is on correctly, and how to fix it of course

[GrimAssasin]

those things are called air fittings or macroline fittings. when you put the macroline in all the way, you shouldnt be able to pull it back out without depressing the collar on the fitting. if you can its not in all the way. if its in all the way on both sides and still leaking, either the macro isnt long enough or it was cut badly, causing the seal to be innefective and leak.

[l1ryan1l]

k i found out it wasnt in all the way in, but now im outta air so i cant be too sure :(, ill whiz by my friends tomarrow to check

[DerMaverick]

DP cut their macro line enough to JUST fit in. It's not the best quality either. Go to your local proshop and pick up some new stuff. It helps out performance too.

[l1ryan1l]

hm the macroline is all the way in the insert, still leaking a bit, even after i put a lil bit of tephlon tape around it, maybe its the line ill try to get a new one

k now its not the Macroline or fittings it's the ASA that is leaking, a temporary solution is i put tephlon tape around the threads of the tank and theres a little leak still. tephlon tape is a temp solution but im looking for a long term, its not my tank either i tried it on two of my other guns and no leakage, thers somethin up with the ASA

[babustos]

Check to see if your fittings are in correctly. Unscrew them with a wrench, then put teflon tape on the threads stringing the same way that the fittings screw in, and put them back in.

[l1ryan1l]

fittings are on just fine, infact, i cant get them off :P, im too scared to just rip em off