REg question

[cobhc237]

Sup guys new here, Ive got a question just got a B2K4 wanting to put a Chaos board in it. I know ill have to switch regs but you guys out there runing cp regs how do u regulate the right pressure going into the gun its supposed to be around 220-300 right?
THANKS

[lotus_esprit5]

Try setting the inline between 250-275psi.

The CP reg has a small screw in the side that adjusts the pressure. Clockwise decreases pressure, counterclockwise increases pressure.

[cobhc237]

i thought cp regs were'nt adjustable?

[lotus_esprit5]

CP's tank regulators aren't adjustable, they are preset only. But CP inline regulators are adjustable.

edit: sorry, I just read your original post and I think I understand what you're asking better now.

The pressure going into the inline regulator from the tank is recommended by ICD to be ~450psi. This would correspond to the output pressure of most Low Pressure preset tank regulators. However, many people have also used High pressure preset tanks (~850psi) and I haven't heard of any problems. I've used both types of tanks on my B2K with no issues. CP's tank regulators are non-adjustable, but either a LP or HP version will work. Bottom line, don't worry about the output pressure of your tank.

The pressure of the inline regulator (the foregrip of the gun) should be 250-275psi. If you replace your inline with a CP, the CP inline reg is adjustable so you can set it to the proper pressure for your gun.