m4 barrel/shroud always turns in adaptor!

[TicaLLioNStaLyN]

Hey guys lookin for advice I got a standard tippmann barrel adaptor with the m4 shroud/ delta ring from ops gear

http://www.opsgear.com/ProductDetails.asp?ProductCode=OG%2DA5%2DM4%2DPICA TINNY%2DHG%2DKIT&CartID=0and

My issue is that when all in and front screws tightened in my a-5 the barrel still turns a quarter like its going to come out but since tightened it wont come out but still swivels and I can't figure out how to keep it so my ergo grip is at the bottom and not on the side, well I can turn it so it's at bottom but annoying that it wont stay in place .......any help is much appreciated!

Thanks in advance

[Orpackrat]

Hey guys lookin for advice I got a standard tippmann barrel adaptor with the m4 shroud/ delta ring from ops gear

http://www.opsgear.com/ProductDetails.asp?ProductCode=OG%2DA5%2DM4%2DPICA TINNY%2DHG%2DKIT&CartID=0and

My issue is that when all in and front screws tightened in my a-5 the barrel still turns a quarter like its going to come out but since tightened it wont come out but still swivels and I can't figure out how to keep it so my ergo grip is at the bottom and not on the side, well I can turn it so it's at bottom but annoying that it wont stay in place .......any help is much appreciated!

Thanks in advance
A little electrical tape as to go between the loose parts.

[bvdave]

I used to have this problem on my A5, electrical tape will prolly work well but I always used hockey tape, the stuff is awesome for paintball i go through a few rolls a month I use it so much, I just buy em 6 rolls at a time from wal mart :D once its in itll "set" almost like momory foam to the shape of whatever its in and it wont unwind cuz after a while of being installed the seams pretty much dissapear

[tonycon]

at the back of the shroud (closest to the marker) there should be a small allen screw=set screw. take a look and if there is one there tighten it down. if not...hockey tape!