Spyder Question?

[Irongut99]

I just got a TL and of course took it apart so I knew what to do at the local field if I had to quick strip it.

When you pull the quick disconnect pin the bolt, spring and striker slide out, but when you try to slide them back in the striker get stuck on the trigger pin and you can't push it any further?? The only way I was able to re-assemble was to remove the trigger assembly??

Is there anyway to avoid this??

[PB ninja]

All you have to do is push the bolt in as far as it will go and then pull the trigger. That will allow the striker to slide in.:)

[Dman]

yep, When putting it back in, just pull the trigger when it gets stuck. This should get the hammer past the sear and let you put the assembly back into the gun. That is the one nice thing about Pirahnas they have a button that does loosens the sear so you can get the hammer past it.

Good luck!!!:)