Just got Impulse.....help............

[JesterDude15]

Couple of questions.....
1. How do you adjust the velocity?
2. How do you lower/raise the PSI?
3. What is the green light on the back of the gun that flashes every time I shoot?
4. Is the reason it wont cock because of an empty c02 tank?
5. How do you adjust the dwell?
6. Is there supposed to be a cover blocking the bolt?


Please answer these questions in "dummy" format.

[ds613]

Read the instructions if you have them.

1. Screw the reg. cover in for higher pressure (higher velocity) and out for lower pressure (lower velocity). Don't give the gun more than 200 psi. You can also adjust the dwell setting if you know what you're doing (you apparently don't). It is preset at the factory.

2. See #1

3. Helps set the dwell. Lets you know youre firing haha. Indicates when you turn you're gun on. Stays lit when battery is low.

4. You don't cock it manually but probably.

5. There is a little hole in the right side of the gun with a little screw (pot switch) in it. Be careful, it doesn't go all the way around. Also, see #3, and read the manual if you have one.

6. No.

Visit http://www.geocities.com/lordofchaos182/iog.html

I hope this helps.

[Edited by ds613 on 05-07-2001 at 09:44 PM]

[ds613]

If you don't know what the dwell is, it's how much air is used for each shot. (how long the valve stays open.)