Help!

[xtremepballman27]

Ok, i got a Expansion chamber kit from 888paintball and heres what i got:
1) Expansion Chamber
2) Macro line kit w/ 90* and straight fittings.
3) Bottomline w/ adoptor.
How should I put this together? They told me to take off the adaptor for the bottomline, put the 90* fitting on the x-chamber, put the straight one on the bottom line adaptor and srew them in. Is this right?

[Wasimodo]

OK, you should get the bottom line on the base of your grips, like you see in the pictures. Take off the bottomline that screws into the ASA and screw in the expansion chamber there. Then take the 90* elbow and screw it into the expansion chamber to that it points to the bottomline. Then, take the macroline and cut it down so that the line fits tightly in the bottomline and the 90* fitting. This is what I did when I put in my reg and it works fine. It might be different for you. I didn't need a straight line fitting, btw.

[xtremepballman27]

Its not gunna be exactly straight is that ok?
Do i need to do anything esle besides what Wasimodo said?

[Wasimodo]

As long as the air gets from your tank to the gun, you should be fine. Don't worry about making it perfectly straight, but obviously, the straighter the better.

[xtremepballman27]

more help from anyone would be appreciaded(SP).

[simon woodstock]

he's pretty much got it covered, you take out the existing bottom line and screw the expansion chaber vertically into the gun (through the asa) next you put on the 90• elbox and screw it into the X chamber, if it doesn't point to your grip, where your bottom line adapter goes (where you screw in your co2) get some thread tape and try to get it to line up, now connect the micro line to the bottom line adapter and screw your bottom line adapter into your grip

[dawgs712]

you nedd teflon tape between the 90* elbow and the hose. otherwise it will leak. it is impossible to tightne it enough without it and if you try you will strip it

[xtremepballman27]

i do need to?(dawgs712)
And simon woodstock, its pretty straight it just has to bent a little. My 90* fitting, part of it pivots. is that right?

[xtremepballman27]

ok someone, more help!

[AutocockerAl]

You should be all set