I swear to God.....

[i like tictacs]

i have NEVER been so FRUSTRATED in my ENTIRE life. BAHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHH

i took out my trigger to adjust the setscrews, to make a shorter pull. i put it back in right, but i put the trigger into the tray and bolt that to the gn, all correctly. when i turn it on to shoot, the blue light doesnt beep when i pull the trigger. it wil do its two little beeps every scecond, but not when i pull the trigger to shoot. it doesnt click either. it just keeps doing its little two beep thing every second. ON TOP OF THAT, the STUPID MAGNET screwdiver somehow pulled over the c-clip from one of the trigger pins. and i tried to get taht off, and the effing clip went flying in some unknown direction. this gun is becoming a horror story of its own now..... :(

[MikeyD]

I feel your pain, I hate those little c-clip bassturds...

[i like tictacs]

22 views and one reply. goes to show youu the laziness of most people. thanks mikeyd :)

[Hoplon]

To prove how so not lazy i am i'll reply even though i have no idea how to help you. Your welcome tic!

[Replicator11]

Boy does that suck!

[The Legend]

It sounds like your setscrews are adjusted in too far.

What trigger do you have?

[Downdog]

it is not aligned with the micro switch right. go get a c-clip put it on, Aline the trigger to the switch and stop crying.

[i like tictacs]

johnny i have an ND blade. any help at all would be good, this=ghay

[The Legend]

Johnny? I'm not Johnny...:)

Anyway, back out your rear stop screw a bit, unscrew it a turn or so, see if it works.

Why did you take out your trigger in the first place? You dont need to take it off to adjust it.

[Deep Sixx]

You have to take the trigger out to adjust the set-screws? That's pretty stupid if you ask me... I'm glad my Eclipse blade isn't like that.

Now about your problem. Your set-screws are out of adjustment. You'll have to back the pre-travel one off some. It sounds like the screw is so far out that the micro-switch is being held down, effectively holding the trigger down. When you do this and turn it on, it gets confused and won't function. If you have to remove the trigger to adjust the screws, it's going to take you FOREVER to get it adjusted properly. Are you sure it has to come off?

As for the c-clips, I can't help you with that... they are a pain. I hate them too.

D6

[i like tictacs]

i got it, woohoo. turns out that the top set screw was sticking out too far.

PS...i had to take out the trigger to adjsut the thing cause my allen wrenches are short as hell. i need some new ones. LOL, sorry leg, i said johnny, heh :)

[Tempest261]

and the effing clip went flying in some unknown direction

same thing happened to me on saturday- I played all sunday with duct tape holding the pin in ;)

[i like tictacs]

Originally posted by Tempest261


same thing happened to me on saturday- I played all sunday with duct tape holding the pin in ;)


YA YAHAHAAHAH


lol, thats funnayyyyyy