Spyder trigger job?

[Irongut99]

I've checked out several sites on what to do.
My problem is getting the pin out to remove the trigger?
I read it has a notched end ect.... But I can't get it to move either way. How hard is it too get out??

[PB ninja]

It shouldn't be very hard, just use a nail or other pointed object and give a couple whacks and it should slide out. You'll know immediatly if your going the wrong way.

[Crisis]

Okay i've done 3 successful trigger mods on spyder (non electro's)

Which ever side has the knureled edge on the pin, you pound on the OPPOSITE SIDE of the pin... The side with the safety warning... it will take a GOOD wack or 2 with a punch and a good size hammer.. I'm not talking about a dead blow hammer or a 4 pounder either a good 22 ounce ball pien hammer and a decent punch (try the nail, just ground off the point first), no need to "custom engrave" that beautiful black anodizing.

I suggest using something of lead to make your FIRST spacer to find "where" in the trigger action your gun fires at, I used a CHEAP.. "Bullet Connector" from radio shack.. I inserted it, put everything back together.. and pulled the trigger, it contacted the "bullet connector" first. so i pulled harder... the bullet connector started to colapse. I continued pulling til the gun fired, then pulled it aproximatly 1/16 of an inch further to make sure it would fire everytime.. after that, dis-assemble the trigger mech, pull out that now perfect sized piece and cut something to fit in the spring without binding to the length of the bullet connector..


There is also another section of this trigger mod, that i TOTALLY recommed.. I WILL STATE THIS NOW.. I DO NOT take any responcibility for ANYTHING YOU WILLINGLY CHOSE TO DO TO YOUR GUN, OR THE CONSEQUENCES IT MAY HAVE TO YOU OR OTHERS OR OBJECTS WITHIN VICINITY!!!!!!!

On the trigger it's self there is a sear contact block that is spring loaded... FILL in that gap with hot glue, solder, what ever you have around that will fill it and stay put.. it takes alot of slack and play out of the trigger and allows you to perform ONE MORE MOD.. shortening the trigger PULL.. you can do it various ways..
i tried it this way. here's links to the trigger mods!

http://www.angelfire.com/co/wakeworld/trigger1.html

http://www.angelfire.com/co/wakeworld/stj2.html