mirco rock

[Jas]

what is a good setting for the micro? And for the maxflow with this setting?(ti pull, delrin blot, brass hammer, ND shaft)

Any input would be great Thanks

[The Legend]

I'm assuming you have the lpr mod all setup and installed correctly.

230psi on your max flow.

Adjust rock up until you reach desired fps.

[Jas]

so there isnt a need to set the rock at a certain pressure?
im trying to get more consistency

[The Legend]

There's not "set pressure" for any gun.

I'd recommend running your dwell just a hair shorter than what it is now, turning your max flow to 200-230psi, and adjusting the rock from there.

It will take some break in time/tinkering, but once you find what works best it will be very consistant.

[Jas]

Nice, thanks

[The Legend]

Yep yep.

[mipaint]

JAs-- which board do you have?

This works well with the new boards...

Take the dwell up to max (keep hitting the "up" until you here the different tone)

push "down" 4 times

Set your pressure up around 200

Adjust the LPR until you hear no difference between a first and second shot (when shooing fast)

That gets you close-- then just fine tune to get the veloicity you want.

THis works with the OLD BOARD

Crank the pressure up on the LPR

set the gun to 200 psi

shoot over a chrno and adjust the dwell. Here is what you do (NOTE THIS IS FOR guns with LPRs only!!!) shoot a couple of shots, increse the dwell. shoot a couple more shots and see if the veloicity when up any. What you are trying to do is increese the dwell to the point where more dwell gives no increese in veloicity. When you hit that point, back the dwell off slightly until you see the veloicity start to drop.

That will give you a good dwell setting-- now back off the pressure on the LPR to get the veloicity you want.

Hope this helps

FOM

[Jas]

yea ive got a new board. im give that a try before my turney or maybe run to an indoor field tomorrow

[Jas]

well thought i had it all set up but the vert adapter would not stop leaking. looks like the oring doesnt have a good enough seal. if i just put some oil on it will that help or should i go and look for a thicker oring.(ND vert adapter) i put my stock adapter back on and no leaks so im kinda bumming

[The Legend]

Try some dow 33 grease on the oring, see if that seals.