velocity adjustment

[Silver Dragon]

how do i change the velocity on my Rat?

[hessians_02]

You obviously didnt read your manuels. Its very easy it says everything in the manuel. If for some reason epbo didnt send any just go to smart parts website and downlaod them. Or before ya made this post you could of gone to faq im sure it woulda said something aobut it. READ YOUR MANUELS they will help you alot. Impulses dont have an on gun velocity adjusting thing. Its all done through regs.

[Skog]

Don't worry about him, although i do have to say that it is pretty annoying that you didn't even bother reading the manuals first.

ok, here is how to set up your imp,

-adjust your pressure till it reads 180psi
-adjust your dwell until you chrono 20 fps below your field limit
-use your max flo to fine tune your velocity

The info i have given is for a stock imp, but as you have a RAT it will no doubt be different due to the upgrades you have, can you tell me what upgrades you have, esp if you have an LPR

Note: it saves time if you simply put your marker specs in your signature

[hessians_02]

saves everyone time if they read there manuels:laugh: Not trying to be a jerk, they just help alot id recomend reading them.

[Silver Dragon]

i did read the manual and it was helpful. i got a vert regulater, tape worm, its a standard stock RAT. i dont know if that helps but thanx anyway

[hessians_02]

Coo

[cris8762]

well then follow the same rules that skog just gave ya (i dont think ya use a lower pressure on a tapeworm)

i got a question, when i runmy imp with VFF i get around 800-900 shots on my 88/3000 crossfire......that's ok but i kinda want a little more, could i run my maxflo at a higher pressure than 15-160? (the vff instructions are to set ur pressure at 150 then adjust dwell....) i've got my dwell set at 12 o clock....i'm just wondering if it's ok to run a imp with vff higher than that to get better efficiency

[Skog]

Originally posted by cris8762
well then follow the same rules that skog just gave ya (i dont think ya use a lower pressure on a tapeworm)

yeah, the tapeworm doesn't need lower pressure

i got a question, when i runmy imp with VFF i get around 800-900 shots on my 88/3000 crossfire......that's ok but i kinda want a little more, could i run my maxflo at a higher pressure than 15-160? (the vff instructions are to set ur pressure at 150 then adjust dwell....) i've got my dwell set at 12 o clock....i'm just wondering if it's ok to run a imp with vff higher than that to get better efficiency [/B]

It is fine to run an imp with a vff at 180 psi, the instructions tell you to use 150psi as an imp w/ VFF at 150psi has the same efficiency as a stock imp at 180psi

personally i am surprised that you are getting such low efficiency,i would have expected at least a couple hundred more shots