trigger"skipping" shots

[StealthElephant]

this morning i went to shoot the rat again...and the trigger was "skipping"...i was pulling the full length and it wouldn't shoot sometimes....low battery? bad solenoid?

near the end i was able to get my ROF up a little bit because i was shoot with my fingers VERY high on the blade....but when i pull on the low curve even when i fully pull it's skipping when i do it fast....do i need to adjust my dwell/maxflo/lpr so i can fire faster? i didn't have this problem yesterday


ok it's not my air source...i just pulled the trigger with no gas and just the gun on....the trigger is skipping...in order to get aconsistent pull i have to pull from the very top of the trigger....i can't use the curve....even when i pull once at the bottom near the curve...it sometimes won't fire even when i have it back as far as the set screw will let it...i have probably fired the gun 400 times with paint and 1000 times dry since i go it....bad battery or what? low battery alert isn't going off....what is wrong?

[DriedGeckoEgg]

Maybe your trigger stoper is to far out. Adjust it in more and see if it works.

[StealthElephant]

it was working fine last night...i haven't touched the trigger since i got the gun (adjust the same as it came)

right now the gun won't fire unless i pull from the top lump of the trigger....it will only fire 1 out of every 10 if i pull at the bottom curve.....what is wrong....

[StealthElephant]

ok i fixed it...apparently the front grip frame screw came loose over the past 24 hours as i was using it....so there was a 1mm gap between the solenoid housing and the trigger frame...you coudl see through the damn gun....i tightened the screw and BAM...the whole length of the trigger works again and im can rip....sorry for overreacting