lp Qs about dragons

[xXhappyAznXx]

hey can spyder internal parts work on dragons?
i want one but i want to go lp... can someone help

[O.a.T]

Yes. I've used "standard" spyder parts to take my hi-compact LP. Right now shooting ~280 fps at ~400 psi. Figure I can go a bit lower with a new bolt.

[xXhappyAznXx]

what is your setup?
you have some spyder internals?
do you think a valve and the bolt will fit it

[O.a.T]

Yup! Spyder (32 degree) turbo valve, Spyder (32 degree) spring kit, Pure Energy Reg, Spyder (Taso) HVC. Looking to get a nylon/delrin bolt and I should be good to go. Oh yeah, bought a new Spyder back for my freak barrel kit. Was shooting .684 insert.

[sdg77459]

I am looking at almost the same setup as your high compact. I just wanna know how is the consistency of the gun?

[matt197]

Originally posted by xXhappyAznXx
hey can spyder internal parts work on dragons?
i want one but i want to go lp... can someone help


its dragun not dragon..............

[O.a.T]

sdg77459: Getting +/- 8fps. Expect to do better as I break in the new reg. In another low pressure setup on a Piranha I was getting +/-4 fps.

[Dixi Normous]

Draguns are all rear cocking. you can use a spyder bolt if it is rear cocking. the valve is the same.

[VerySolidSnake]

but wait a second, if u got a standard spyder rear cocking bolt, would you have to get a beaver tail on the dragun?

[LeGeNDse]

if the dragun you have has a snap back contraption then all you have to do is take off the snap back assembly and take out the screws that set the pin in and put it on the other bolt.

[xXhappyAznXx]

thanks everyone
i guess ill be getting a dragun soon
and put spyder parts into it