PI-E2 questions

[Aglar]

Does the PI-E2 come with a reg? If so, is it any good?

Also, does the E2 have a venturi bolt?

I'm mainly trying to decide if I should sell my Piranha STS G3 and buy a PI-E2. The E2 just seems too good to be true (at $149.95 it's cheaper than what I paid for my STS G3!).

[halB]

unfortunately it has a venturi, but dont worry, it can be easily removed

[MiLoco1980]

Splatdogs.com has the E2 for $129! That is where I plan to order mine!

[Dixi Normous]

easily removed???? BS!!! they glue the set screws in. I broke my allen wrench trying to unscrew it!!!!!

[nharms5]

The Black Dragon is basically a Spyder clone with an electic grip.. it cycles at high pressure, like any Spyder/ Spyder clone. The BD comes with a reg located at the ASA, this isn't much of a reg... but the BD really doesn't need one. A nicer regualor would only starve the gun of air and cause the gun to not shoot as far. So... unless you like arching your shots... don't invest (waste) money on a fancy reg. The tank is regulated at 650 to 850 psi anyway... this is just fine for the BD because the internal valve cuts this down to what you need it to be anyway. The expansion chamber keeps the pressure about a consistant as you need it (note: CO2 will not be as regulated at HP!) so you don't need a reg to do that either. If you are looking at getting a BD go to www.paintballgear.com they might not have the best prices anywhere... but they make up for this with superior service. If it breaks... and it wasn't your fault... they WILL MAKE THINGS RIGHT!!! I hope this helped.