Custom Milling!!! Check this out

[pballraven]

Hey everyone. I just got my Impulse milled by a company called Three R Plastics out of Round Lake, IL. Check out the pic. They can mill yours for a pretty decent price too.

[dfd03]

its ugly

[StealthElephant]

shoulda sanded those edges down...looks like you could cut your finger or rip your jersey if it gets caught....nice milling....but it doesn't look clean....and raw body is showing....

PERSONALLY...if your gonna go for a custom mill job....get a full job....(not just the tail of the marker) but get a nice job on the whole body...and reanno the gun...cause it's not cost efficient to mill just the back and reanno.....and it looks fugly with raw aluminum

[pollacjw]

not bad...

I would smooth the edges and wet sand and buff it then get a new anno.

A fade would look sweet IMO... especially if it faded right at the milling.

[pballraven]

thanks for your opinion....now run along young one...

[pballraven]

sorry my last post was directed at dfdo3.

yeah we are gonna sand it down and do more milling. Ill post again when its all done...

[sk8rpunk0000]

I was the one who did the milling and such. It is a little bit scary when the CNC starts to make the first cut. This came out better than expected though. Many other designs can be made too. Imagination and critical areas on markers are your only limitations./ Thanks

andrew

[StealthElephant]

yea the milling is nice...once you clean it up and reanno im sure it'll look very nice

[dkm]

You'll put someone's eye out!