cant keep consistant

[p8ntballboy4lyf]

ok i am having trouble keeping my gun consistant. this has been going on for some time. right now i have a 2k2 impy with delrin bolt, bizerk barrel, blade trigger, LPR with a Micro Rock. running the Max-Flo at 240, dwell at one push and ajusted the Micro Rock to 285fps. but its not staying at 285fps. i have a +/- 10 fps spike. i have put many cases of paint through it, and have claened and relubed the gun and reg many times.

[p8ntballboy4lyf]

ohhhh yeah also am using HPA/N2

[pollacjw]

Is the battery fresh? If if you think it is, change it and see what happens- use a new battery.

Valve- did you clean it well?

[p8ntballboy4lyf]

new battery (energizer) yes have cleaned valve well

[Reklats]

Here's a REALLY important thing for consistancy.

Make sure there is absolutely NO dow on the hammer. There can be a little on the ram shaft, but on the actual black hammer at the end that strikes the valve, there should be absolutely no dow at all. It doesn't touch the sides, so it doesn't need to be lubed. Lubing the hammer will make the gun inconsistant.

I hope that helped... I registered here just to reply to this :)

[p8ntballboy4lyf]

dont worry, thats the first thing i did was make shure is was skweeky clean of DOW. and befor putting back into gun cleaned out the inside, so when sliding it back in non gets on it.

[pollacjw]

if you still have had no luck then check wolvies FAQ... cleaning the solenoid. Its under FSDO it explains how to clean the noid. Sounds like thats your problem. That is of course if everything else is working, and the gun has at least 4000 shots through it, and your maxy is clean....

[p8ntballboy4lyf]

every thing it working great and yeah it has well over 4000 shots, id say iv put about 10-15 cases through it. clean the gun, and maxy after every day of use. and i just had the solenoid cleaned, but i will claen it again and try that.