Brand new Impulse,wierd problem

[magis70]

so i got this new 2k2 impy(cricket board),it was cycling but not firing,my local store replaced the board,works fine now,then i took the frame off to adjust the trigger spring,put it back togethor,later that night the noid stops clicking,next day i take it apart,checking as i go,finally get it apart,press the white button on the noid a few times,nothing happens,cus theres no air,then bam,it clicks when i pull the trigger again,woo hoo,now....wtf?Anyone got any ideas?

[pollacjw]

PEOPLE PLEASE SEARCH BEFORE ASKING A QUESTION:

Try a search for "***solenoid click***" and you will find out whats up.

[PhishPhactor]

if your going to take the time to post, tell him what you think, stop with the stupid do a search mumbo jumbo. Good god.

There couldt be a lose wire, or it might be connected all the way. Plus when you take it apart, you have to make sure all the connections are the same when putting it back together. Some connections can shack loose after fireing for awhile.

[magis70]

no,i hadent even aired it up yet,it was just starting to do what it did before,but i aired it up today and everything is fine,so hopefully it stays that way...