Matrixies and choping?

[DriedGeckoEgg]

Whats the dealyo with matrix and choping. I know truma used to use revvies with their matrixies, i doubt they choped. Whats the lowest pressure you can set your LPR at?

[Predator2]

If you have LPR, you won't chop, you don't how much pressure your LPR is putting out, but it is estimated at 80 psi.

To set a trinity properly, turn in the trinity all the way until there is no pressure going to the solenoid, then turn it out while you fan on the trigger (about 6 BPS) and when it starts to fire w/o any skips turn it up another 1/2 turn.

After you do that, rapid fire some paintballs through it and if it skips, turn it up just a little bit till it's fine and it won't chop, try a chop hold a ball half way in the chamber and fire it and the bolt should bounce off of it.

[Mr_Toad]

30,000 balls no chops

i set my matrix like this. I chrono the matrix as usual so its in the 280-290 fps range then dial out the LPR till the matrix stops firing then give the LPR a 3/4 turn back in so that it starts firing again then rechrono. then put a few balls through it till your satisfied.

This is how the Techs at diablo uk setup the matrix.

[DriedGeckoEgg]

Whats the highest pressure the selonoid can take? how do i know i'm not turning the vertical reg up too high?

[Predator2]

well the solenoid can hold 550 psi, maybe a lil more, but before you can reach anything near that pressure, you will get leaks springing up everyone around the gun.