m98 pro seal problems!!!!

[da_TM98]

i have recently installed the psycoballistics M98 pro seal powertube and
bolt and now every time i pull the trigger all it does is act like its on full auto, like the shear isnt catching the rear bolt or there isnt enough pressure for the bolt to go back. i got my installation directions from m98center.com which is a reliable source of how tos i think i just did something wrong is there anyone that can help me!!!

[CountyPaintball]

Make sure your ball stopper (little orange rubber piece) isn't in backwards. It should be positioned so the ball can roll over it easily on it's way out.

Also, make sure you have plenty of air pressure in your tank. Also check to make sure your rear bolt O-ring is in good condition, your linkage arm is in place and the halves are screwed together tightly enough that the linkage arm can't wobble in it's groove.

All those things could cause what you're describing.

Mike