Max-Flo leakage

[Spazz]

Hi, I just got a new impulse and I am having some problems with it. I tried screwing in my nitrogen and it started leaking where I screwed in the nitro. I lost about 1000 psi in the 3 seconds it took me to unscrew it. I have tried everything. I have put 1, 2, and 3 extra o-rings in the hole but it dosnt help at all. I have replaced the o-ring on my nitrogen but that didnt work either. My friend had the same problem with his nitrogen, but all he had to do was put one o-ring in where you put the nitro in. I have talked to the Action Village where I got it from and they didn't know what it was, I have talked to Smart Parts and they didn't know what it was either. Does any one have any answer for my problem? thanks bye.

[thebluenu]

use the o ring trick, put an o ring or 2 in the asa (including another on your tank) then sqrew in tank...... its just how the max flows are made, for use with smart parts on off valves...... its really stupid....

[Spazz]

I already tried that, the more o-rings i put in the worse it makes it.. :(

[PhishPhactor]

well, for one, it is for sure an oring, or a busted valve. You may need a New flange, or one of the O-rings with in the Max-flo might be torn. Clean the Maxxy, and then check your tank. Are you running a cheap as$ tank? if so check out the Tip of the tank, and make sure nothing is bent up so the air can't create a seal. Also bring it into a shop and see what they can do.