Changing the output pressure of a WGP reg

[orryn]

I jsut got a WGP regulator off of ebay, and I couldn't figure out how to change the output pressure. If any of you could tell me, that would great. Thx.

[krasher]

take off the bottom cap, see where there is a place for a hex key on the bottom? Theres your adjustment place.

[Silent Knight]

if you look at the reg, you will notice that the reg is made up of two sections. you can unscrew the bottom section of the reg, and use a allen wrench to adjust the pressure. ...hmmm im confused now, I believe turning the wrench clockwise (right) will decrease ouput pressure (make it lower) crap, i just confused myself, and i have a cocker too.

[orryn]

cool thx...also can you tap a gauge on it?

[Silent Knight]

actually no you cant, and i wouldn't suggest tapping it to put on a gauge. Just so you can have adjusting the reg much easier, i know you can buy a adjuster cap for the reg that replaces the bottom cap (the part you take off to ajust the reg) the adjuster cap allows the WGP reg to be externally adjustable.

[krasher]

You could do that, just have a machinist do it if you don't really know much about that.

I think it is the opposite of normal regs (adjustment) so I think it is clockwise to go up...or is that the sledgehammer? Ok, now I'm confused too!

[orryn]

thx guys I found it. However, does anybody know which way to turn it to adjust the pressure?