View Single Post
Old 01-23-2004, 10:54 AM   #4
jdubau55
Master of the Dremel
 
jdubau55's Avatar
 
Join Date: Dec 2003
Location: Dublin, VA
Send a message via AIM to jdubau55 Send a message via Yahoo to jdubau55
uh hum? milling.......it gets asked a lot too. a lot of the places that do anodizing on markers also do custom milling. dont forget to just run a search on Yahoo or another internet search engine, as well, before posting a simple question as to where or who does this and that.
__________________
Theres some that you've wronged, Theres some that you set free, There's some that deny,
There's some that fall on their knees..Today I set aside a friend

My Gat: G3 VTL E-Force, PDP board and eye mod, Egg 2, Crossfire 88/45, BOSS delrin bolt, AA Vigilante (LP), PMI drop, Custom blade trigger, Custom switch setup
jdubau55 is offline   Reply With Quote