View Single Post
Old 01-30-2004, 05:39 PM   #13
lucwil
King of the no pants
 
lucwil's Avatar
 
Join Date: Jul 2003
Location: Ontario Canada
to check the side valve secure pin, just put your hand beside it when u shoot, if air comes out, its leaking, you can seel it up with a bit of blue locktight if you're careful. you can check the bottom one if the frame is off, just check for air pressure coming out and seal if neccesary. about the cup seal star, as far as i know, it just helps guide the cup seal. if it is gone it really shouldnt be a big problem because the valve pin is support enough. even if it was gone, the valve would still open and this should have no effect on recocking, its always possible though. other than that i dont know what it could be . about your cup seal not threading, do you mean its on there right, you just can't twist it off? if so, dont try, it means its melted right on.
__________________
------------------------------------------------
Marker:
Limited edition Bushmaster 2000
AKA Sidewinder
Zenitram Valve & 15* ASA
Freak Kit
Halo B
------------------------------------------------
My Feedback

Last edited by lucwil : 01-30-2004 at 05:43 PM.
lucwil is offline   Reply With Quote