View Single Post
Old 01-30-2004, 06:52 PM   #16
lamron eb yhw
paintballr87's Avatar
Join Date: Aug 2003
Location: Ontario, Canada
Originally posted by lucwil
if you're having recocking problems, one thing to check are the valve secure pins. one located on the side of the marker above the frame. and one is usually located on the bottom of the receiver if you take the frame off. make sure no air is leaking out there because if it is there wont be enough pressure to push the striker back.
Yup I have seen the same problem in a few spyders and if the T.E.S valve system holding pin is the same then that could be the problem.
Marker: 1 chrome minimag, BL expansion chamber,dye boomstick
looking to sell my Mini mag.
Originally posted by PbAllWiZZ:
My gun is just a bat with PB's taped to it
Originally posted by drchocolate176:
wire your doorbell to shoot a stream ofpaint/flames/gnomes/water/chairs.etc. whenever it is rung.
Originally poster by firekow: NDN, take pity on him, he's not using the metric system yet.
paintballr87 is offline   Reply With Quote