View Single Post
Old 08-19-2004, 03:32 PM   #18
Psycho_warden
The Phantom Guru
 
Psycho_warden's Avatar
 
Join Date: May 2004
Location: Spokane, WA
I just did a job on mine. I drilled a hole behind the trigger, from where it trips the sear, and i got a nail and cut off the head and a few millimeters below the head. I put that in the hole and on the bottom i soldered it, because i have the aluminum, i fugured that is stronger than any glue. So now the trigger slop behind the pull is almost entirely eliminated.
__________________
CCI-OT...we miss you

Last edited by Psycho_warden : 08-21-2004 at 10:53 AM.
Psycho_warden is offline   Reply With Quote