Paintball Forums - View Single Post

mangyan · 08-26-2004, 10:19 AM

here's what i did with my TL+
some of you might not like it coz it involves drilling you frame
but hey,it's your gun right,get drill bit a bit smaller than 3/16
drill the hole out and put in a 3/16 roll pin you may have to grind the pin for exact length,then drill another hole whre the trigger spring is,tap it 8-32,get an 8/32 screw cut it at 7/16 length,screw it in from the bottom(trigger housing)you may have to grind the screw a bit coz not all guns are the same,and you know what,the head of the screw will work as trigger stop
now you cut your triggeer pull by 50%

note:if the trigger doesn't release the sear,you unscrew it a bit until it release

08-26-2004, 10:19 AM	#17
mangyan Registered User Join Date: Aug 2004 Location: Canada	trigger job here's what i did with my TL+ some of you might not like it coz it involves drilling you frame but hey,it's your gun right,get drill bit a bit smaller than 3/16 drill the hole out and put in a 3/16 roll pin you may have to grind the pin for exact length,then drill another hole whre the trigger spring is,tap it 8-32,get an 8/32 screw cut it at 7/16 length,screw it in from the bottom(trigger housing)you may have to grind the screw a bit coz not all guns are the same,and you know what,the head of the screw will work as trigger stop now you cut your triggeer pull by 50% note:if the trigger doesn't release the sear,you unscrew it a bit until it release Last edited by mangyan : 08-26-2004 at 10:31 AM.