View Single Post
Old 06-09-2005, 06:37 PM   #16
bluesboyk3
Bushamster
 
bluesboyk3's Avatar
 
Join Date: Sep 2002
Location: Houston, Tx
Send a message via AIM to bluesboyk3 Send a message via Yahoo to bluesboyk3
1. for older bushy with the 2 LPR holes:
Take a dremmel and connect the 2 holes into 1 line. Now u can use a quarter or a flathead screwdriver - that's what i did

2. If u have a blind bolt and the ball detent tension is too soft:
Cut about 1/8 " of a ball pen spring and just add it up to the original spring. It'll make the bolt to hold the bolt pin tighter.
3. i did the bright red LED.
4. 25 mg microswitch.

also not in pic is FS feedneck and FS ASA.
__________________
quote:
--------------------------------------------------------------------------------
Originally posted by ArchDingo


to bad theres not an idiot check button
--------------------------------------------------------------------------------
bluesboyk3 is offline   Reply With Quote