More Pix
I had some more photos commemorating the final stages of this Excellerator 5.0's transformation - just figure I'd post them.
This is the pre-use final stage though: no macroline (still waiting for my Evil bottomline), Palmer's stabilizer requires calibration and I need to go to Home Depot to see if I can get some offset screws for my drop forward (no longer using inline screws as was present on the stock e-frame)
My hopper is off to the side. I just put on a RIP drive and Z-board, but plan to disassemble the whole shell to airbrush it maybe.
On that note, I'm not too sure if I'd want to airbrush my marker. It turns out the parts I've replaced seemed to have the right amounts of accents in the right places, so I'll leave the body the way it is...but maybe airbrush the bottom chamber (holding valve, striker bolt, spring, etc) black to match the 15* inward ASA block.
__________________
 JT Excellerator 5.0 - Zaibach Custom
JT 14" Two-piece Barrel
RMR Killstick Delrin Bolt
Kingman ESP Frame w/ Rocking Trigger
Trinity 15*(inward) ASA block
Maddman Rocket LP Valve
Palmer Stabillizer (w/ PHAT mini 700psi gauge)
InYoFace Offset Sight Rail
BSA RD30/22 SIL Red dot scope
Halo Reloader B (w/ RIP drive & Z-board)
Fireball Mountain Stiletto Drop
Evil Bottomline ASA w/ on/off
Pure Energy 20oz CO2 Tank (anti-siphoned)
 Busy w/ Custom Airbrushed Design
|