View Single Post
Old 01-26-2006, 06:51 PM   #2
Dark Master
Registered User
 
Dark Master's Avatar
 
Join Date: Sep 2003
Location: Pk, NY
Step 11. (Skip if you have a mech)
Now you have to remove the grips on the E-Blade. To do this, get a 5/64th hex key and remove the 6 grip screws that hold the grips to the body.



Step 12.
(Skip if you have a mech)
Remove the battery by lifting up on the bottom of it.



Step 13.
(Skip if you have a mech)
Now you have to remove the cocking solenoid and a eye wires from the board. It's the left (2 wires, black and red) and right (4 white) wires. Not the middle.





Step 14. Electro Only.

Now, remove the frame from the body. Do this by removing the 2 screws that holds it to the body using a 1/8th hex key. When you remove the screws, gently seperate the body from the frame. Be careful to of the wires, since the eye wire and eye cover will probably fall freely, since they aren't connected to anything.



Step 14. Mech Only.
Now, remove the frame from the body. Do this by removing the 2 screws that holds it to the body. Each screw is different. I used 1/8th allen key. Yours might be different. After you remove the screws, tilt the frame left if your looking at it from the back of the body, then slide the frame off the timing rod.









Step 15.

Remove the IVG. Do this by looking at the back of the body. Get a 3/16th hex key, insert and remove till it comes out of the body. Then tilt it down and the main spring will slide out.




Last edited by Dark Master : 01-27-2006 at 10:43 AM.
Dark Master is offline   Reply With Quote