View Single Post
Old 12-20-2006, 11:43 AM   #58
zdmechanic
Registered User
 
Join Date: May 2006
Location: Connecticut
Ok, heres what I have for my project gun so far:

-Excellerator 4.0
-5.0 ball detent and cover (will fit, and wont crack like older one)
-Lapco vertical adaptor
-Jt 14" one piece barrel
-Shocktech asa
-Trinity 6 stage exp. chamber
-Tac 5 quick strip pin (highly recommended for all 3.0 and 4.0 models.)
-wrapped parts in rubber tape

The parts that I have or am debating getting are the following:

-Delrin bolt (have, just not installed)
-Q-loader
-horizontal scope mount
-Rocking trigger (It will work, however because the hammer is bigger, it needs to be shaved and cut to fit. Or, find a thin piece of rubber and cut it to fit between the gun frame and the trigger frame. Then you can use spyder compatible e-grips.)
Attached Images To view attachments your post count must be 0 or greater. Your post count is 0 momentarily.

Last edited by zdmechanic : 03-07-2007 at 04:23 PM.
zdmechanic is offline   Reply With Quote