View Single Post
Old 05-14-2007, 06:17 AM   #1
jhorgan
Paintball = Life
 
jhorgan's Avatar
 
Join Date: Sep 2003
Location: Tyndall AFB, FL
Send a message via Yahoo to jhorgan
Pressure Spikes when 1st aired up...

When I first air up the Quest I've noticed a huge pressure spike. Anywhere from 200-250psi (I currently have the LPR set at 95psi), then after I take the 1st shot it is OK and doesn't happen again. I've taken apart the HPR and LPR regulators to try and correct the problem, but it is still happening (although less than before).
All of the seals in both regs look good, no noticeable nicks or damage. The only thing that I saw was the seal that is imbedded into the pin inside of the LPR seems like it needs to be replaced. Is that seal replaceable or do I need to pick up a new part? Any other recommendations?
__________________
-X

Cyborg RX
Droid
06 Cyborg

I Fight for MacDev!!!!
jhorgan is offline   Reply With Quote